Skip to content

Product Usage 🎮

Operating Modes

  • Sinusoidal function: Simulation of predefined earthquakes.
  • Preloaded earthquakes: Control via graphical interface.

🔌 Setup and First Use

Follow these steps to properly set up the shaker table:

  • Connect the power cable to the included 12V power supply.
  • Create a WiFi Hotspot
    SSID: p-sensors.com
    Password: p-sensors.com123

  • Turn on the main switch and verify the LED indicator turns on. Once connected to WiFi, the green LED will stop blinking.
  • Open the control software
    In your web browser, go to p-shaker-(6 digit device ID).local.

For example, if the device ID is 45f38a, open:

  • p-shaker-45f38a.local
  • p-motion-45f38a.local

For software versions released in 2025 and later, simply open:

  • p-shaker.local

If this is your first time accessing the device, you will be asked for an activation key.
The activation key can be found on the device’s warranty card. - Run your first test
Enter the sinusoidal function and click Start. The shaker will perform auto-calibration and centering before starting.

If the table does not respond, check the Troubleshooting section.